Envirolite EV24P3T850DM Manuel D'instructions page 5

TROUBLESHOOTING:
Light will not turn on.
Light is too dim.
Fuse blows or circuit
breaker trips when light is
turned on.
PRODUCT MAINTENANCE:
1. To clean the outside of the fixture, use a dry or slightly dampened clean cloth
(use clean water, never a solvent) to wipe the surface of the fixture.
2. To clean the inside of the fixture, first disconnect power to the fixture by turning
off the circuit breaker or by removing the fuse at the fuse box. Next, use a dry or
slightly dampened clean cloth (use clean water, never a solvent) to wipe the
interior surface of the fixture.
3. Do not use any cleaners with chemicals, solvents or harsh abrasives. Use only a
dry soft cloth to dust or wipe carefully.
The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for a
period of five (5) years from date of purchase.
purchaser and only to products used in normal use and service. If this product is found to be defective, the
manufacturer's only obligation, and your exclusive remedy, is the repair or replacement of the product at
the manufacturer's discretion, provided that the product has not been damaged through misuse, abuse,
accident, modifications, alterations, neglect or mishandling. This warranty shall not apply to any product
that is found to have been improperly installed, set-up, or used in any way not in accordance with the
instructions supplied with the product. This warranty shall not apply to a failure of the product as a result of
an accident, misuse, abuse, negligence, alteration, or faulty installation, or any other failure not relating to
faulty material or workmanship. This warranty shall not apply to the finish on any portion of the product,
such as surface and/or weathering, as this is considered normal wear and tear. The manufacturer does
not warrant and specially disclaims any warranty, whether expressed or implied, of fitness for a
particular purpose, other than the warranty contained herein.
disclaims any liability and shall not be liable for any consequential or incidental loss or damage,
including but not limited to any labor/expense costs involved in the replacement or repair of said
product.
All manuals and user guides at all-guides.com
Possible Cause
1. Power is off.
2. Lamps are not
installed correctly.
3. Faulty switch.
4. Faulty wire connection. 4. Check wiring.
1. Crossed dimming
wires.
1. Crossed wires or
power wire is grounding
out.
LIMITED WARRANTY
Corrective Action
1. Make sure power supply is on.
2. Ensure that the lamp side labeled "power"
is connected to the lamp holders on the side
closest to the access plate. If lights still do
not turn on, flip the lamp direction.
3. Test or replace switch.
1. Make sure to insulate the grey and purple
dimming wires with electrical tape if the
1. Check wire connections.
This warranty applies only to the original consumer
The manufacturer specifically
Page 5