Polk Audio hinge wireless Manuel page 9

All manuals and user guides at all-guides.com
d. If the product does not operate normally by following the operating instructions. Adjust only
those controls that are covered by the operating instructions, as an improper adjustment
of other controls may result in damage and will often require extensive work by a qualified
technician to restore the product to its normal operation.
e. If the product has been dropped or the cabinet has been damaged.
f. When the product exhibits a distinct change in performance this indicates
a need for service.
19. Replacement Parts. When replacement parts are required, be sure the service technician has used
replacement parts specified by the manufacturer or that the parts have the same characteristics as the
original part. Unauthorized substitutions may result in fire, electric shock or other hazards.
CAUTION: Danger of EXPLOSION if battery is incorrectly replaced.
WARNING: Do not expose batteries or battery pack to excessive
heat such as sunshine, fire or the like.
20. Safety Check. Upon completion of any service or repairs to this product,
ask the service technician to perform safety checks to determine that the
products are in proper operating condition.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
(1) Reorient or replace the receiving antenna.
(2) Increase the separation between the equipment and receiver.
(3) Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
(4) Consult the dealer or an experienced radio/TV technician for help.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation
of the device.
product disposal
Certain international, national and/or local laws and/or regulations may apply regarding
the disposal of this product. For further detailed information, please contact the retailer where you
purchased this product or the Polk Importer/Distributor in your country.
A listing of Polk Audio Importer/Distributors can be found on the Polk website
`www.polkaudio.com or by contacting Polk Audio at: 5601 Metro Drive, Baltimore, Maryland
21215, USA. Phone: +1-410-358-3600; in California: 1-800-377-7655.
9