Sinbo SS 4031 Mode D'emploi page 8

All manuals and user guides at all-guides.com
CLEANING YOUR SHAVER
Warning: to prevent electric shock or personal injury, disconnect the power cord from
the shaver and turn the shaver off before cleaning.
For cleanliness and convenience, we recommend that you clean your shaver with water
and liquid hand soap. Regular cleaning will keep your shaver in good condition while
preventing odors or bacteria from developing, and maintain the cutting performance.
With the system outer foil in place, apply some hand soap onto the outer foil.
Turn the shaver on and pour some water over the outer foil.
After about 10-20 seconds, turn the shaver off. Remove the foil frame and clean it with
running water.
Wipe off any moisture from the shaver with a dry cloth and remove the protective cap
to allow the system outer foil to dry completely.
BRUSH CLEANING
Squeeze the system outer foil release buttons and lift the system outer foil upward to
remove it. Remove the inner blades one at a time by grasping it firmly at both ends and
pulling it straight away from the shaver. Clean the outer foils, the shaver body and the
trimmer with the long brush. Clean the inner blades with the short brush by moving it
in the direction in figure 8 (A). Do not use the short brush to clean the outer foils.
REPLACING SHAVING HEAD COMPONENTS
It is recommended that you replace the system outer foil at least once a year and the
inner blade at least once every 2 years to maintain your shaver's cutting performance.
REPLACING THE INNER BLADES
Squeeze the foil frame release buttons and lift the foil frame upward to remove it.
Remove the inner blade, one at a time, by grasping them firmly at both ends and pulling
straight away from the shaver. To insert the new inner blade, hold the blade, one at a
time, at both ends and press downward until it snaps into the shaver.
FOR ENVIRONMENTAL PROTECTION AND RECYCLING OF MATERIALS
This shaver contains Nickel-metal hydride batteries.
Please make sure that the batteries are disposed of at an officially assigned location, if
there is on in your country.
CAUTION
Do not charge the shaver where the temperature is below 0˚C (104˚F), where it will be
exposed to direct sunlight or a heat source, or where there is a lot of moisture.
Use only the included adaptor.
Dry the shaver completely before charging it.
Keep the adaptor away from water and handle it only with dry hands.
Grip the adaptor when disconnecting it from an AC outlet, tugging on the power cord may
damage it.
- 7 -