Publicité
Les langues disponibles
Les langues disponibles
QUICKLY EVALUATE AP & BRIDGE MODES
Quickly evaluate the ACKSYS device in AP role
➢ You need a second computer (PC2) with a working Wireless connection.
➢ Set up the PC2 Wireless network interface according to the default
parameters of the ACKSYS AP device (802.11gn, SSID "ACKSYS", no
security).
Quickly evaluate the ACKSYS device in client role
You need two ACKSYS devices, and a second computer (PC2) with a wired
LAN connection.
➢ Set up the IP addresses according to the picture above and set the
device connected to PC2 to Client (infrastructure) role.
From each PC, start a command prompt and run the ping command to verify
the link.
From PC1: type ping 192.168.1.2, verify the answer returned by PC2
« Answer from 192.168.1.2... »
From PC 2: type ping 192.168.1.1, verify the answer returned by PC1
« Answer from 192.168.1.1... »
Notice: The State LED is flashing until the bridge connects to the AP.
None of the LED indicators turns ON
• Verify the power supply (voltage, cabling).
The relevant LAN led indicator stays OFF
• Check that the remote device is turned ON.
• Try to connect to another device.
• Use another Ethernet cable.
The Wi-Fi link does not come up
• Make sure that the Wi-Fi interface is enabled (warning, it is disabled
by default factory settings)
• Make sure that the Wireless parameters of the Client (case sensitive
SSID, 802.11 mode, radio channel and security) match those of the
AP.
• Check the radio conditions: distance between devices, placement of
antennas, interferences and obstacles to radio waves propagation.
• Try with all securities and encryption settings temporarily disabled.
• Try using the product with factory settings as shown in the "Quickly
evaluate" section.
• Try another radio channel.
TROUBLESHOOTING
-
-
6
Publicité
