Publicité
Les langues disponibles
Les langues disponibles
1. Plug the antennas
Plug the antennas of your choice (not provided as standard) on the QMA type
connectors of WiFi interfaces.
WARNING:
Always use the ANT1 connector first, then ANT2...
It is recommended to connect a 50 ohms terminator on unused
antenna connector. If not, it may disturb radio link quality and data
throughput, and as well as waterproofness.
2. Connect the power supply
See the "specifications" section about the characteristics of the power
supply.
The device has no ON/OFF switch. It turns-on automatically when power is
applied. Check LED Power
•
Power1 LED is ON if Power1 power supply or PoE++ source is ON.
•
Power2 LED is ON if Power2 power supply is ON.
The Diag LED lights red when the product starts up and will turn green once
the product is ready for use.
PoE++ models must be exclusively powered by a PoE++ power source
(802.3bt type 3) connected to LAN2 connector (the use of the POWER M12
connector on PoE++ models, is not functional).
3. Connect the Ethernet cable
•
Plug the Ethernet cable to the device's LAN1 or LAN2 M12 connector.
•
Check that the corresponding LAN LED turns ON at that point.
HARDWARE INSTALLATION
-
-
2
Publicité
