Télécharger Imprimer la page

Hilti TE 30-ATC Mode D'emploi page 22

Masquer les pouces Voir aussi pour TE 30-ATC:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 26
All manuals and user guides at all-guides.com
5 Operation
5.1 Preparations at the workplace
CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Unplug the supply cord before making adjustments to the power tool or before changing
accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1.1 Fitting the side handle
1. Release the side handle clamping band by turning the handle grip.
2. Slide the side handle clamping band over the chuck from the front and into the recess provided.
3. Set the side handle to the desired position.
4. Tighten the side handle clamping band by turning the handle grip.
5.1.2 Adjusting the depth gauge (optional)
1. Press the release button on the side handle.
2. Adjust the depth gauge to the desired drilling depth.
3. Release the release button.
4. Check that the depth gauge is secure.
5.1.3 Removing the chuck
CAUTION
Risk of injury! The depth gauge, if fitted but not used, may hinder the user.
▶ Remove the depth gauge from the tool.
Note
Set the function selector switch to the
1.
Disconnect the supply cord plug from the power outlet.
2. Grip the chuck as shown in the illustration and pull the three chuck release rings upwards.
3. Lift the chuck up and off.
5.1.4 Fitting the chuck
CAUTION
Risk of injury! The depth gauge, if fitted but not used, may hinder the user.
▶ Remove the depth gauge from the tool.
Note
When changing the chuck, set the function selector switch to this position:
1.
Disconnect the supply cord plug from the power outlet.
2. Grip the chuck as shown in the illustration and pull the three chuck release rings upwards.
3. Fit the chuck on to the chuck mount.
4. Rotate the chuck until it engages in position.
5.1.5 Fitting the accessory tool
Note
The use of unsuitable grease can cause damage to the tool. Use only genuine Hilti grease.
16
English
Printed: 27.06.2017 | Doc-Nr: PUB / 5151646 / 000 / 05
3
4
5
"Chiseling" position for changing the chuck.
5
6
.

Publicité

loading

Ce manuel est également adapté pour:

Te 30-avr