Kapego LED RF-120 Mode D'emploi page 11

Manual
2. Touch-Remote
Dimensions (LxBxH):
Battery:
Distance:
Frequency:
5. Installation
1. Connect Touch-Controller with the RGB RF Flood Light
a. Switch on the Power of the RGB RF Flood Light and wait ca. 1s and then push the
"ON" button on the Touch-Controller, after that the LED fl ashes up 3 times, then the
Touch-Controller and the Controller are connected.
b. If this step isn't working please try again.
2. Disconnect Touch-Controller from the RGB RF Flood Light
a. Switch on the RGB RF Flood Light and wait ca. 1s and then hold the "ON" button again
till the LED fl ashes up 9 times, then the Touch-Controller and the RGB RF Flood Light
are disconnected.
Now you can address the RGB RF Flood Light again with the same or another Touch-
Controller.
110 x 52 x 20 mm
2x AAA batteries
ca. 20 m
2,4 GHz
5
D P
S
On/Off
Colorwheel
D (dim)
S (speed)
P (program)