SilverStone Decathlon Serie Mode D'emploi page 6

3.PROTECTION
3.1 Over current protection
The power supply shall have current limit to prevent the +3.3V,+5Vand +12V
outputs from exceeding the values shown in the following Table. If the current
limits are exceeded the power supply shall shutdown and latch off.
Voltage
+12V
+5V
+3.3V
+5VSB
3.2 Under voltage protection.
In an under voltage fault occurs, the supply will latch all DC outputs into a
shutdown state when +12V,+5V & +3.3V outputs under 60% of it's maximum
value.
3.3 Over voltage protection
Output
+12 VDC
+5 VDC
+3.3 VDC
3.4 Short circuit
An output short circuit is defined as any output impedance of less than 0.1
ohms. The power supply shall shut down and latch off for shorting the +3.3
VDC,+5 VDC,or+12 VDC rails to return or any other rail. Shorts between
main output rails and +5VSB shall not cause any damage to the power
supply. The power supply shall either shut down and latch off or fold back for
shorting the negative rails.+5VSB must be capable of being shorted indefi-
nitely, but when the short is removed, the power supply shall recover auto-
matically or by cycling PS_ON#. The power supply shall be capable of
withstanding a continuous short-circuit to the output without damage or
overstress to the unit
Over Current Limit (Iout limit) %
120% minimum; 160% maximum
120% minimum; 160% maximum
120% minimum; 160% maximum
120% minimum; No damaged
Minimum Nominal
13.4 15.0
5.74 6.3
3.76 4.2
Maximum Unit
15.6 Volts
7.0 Volts
4.3 Volts
05