Philips HD5730 Mode D'emploi page 31

Problem
I want to brew
espresso from
ground coffee, but
no espresso comes
out of the appliance.
The coffee does not
come out of the
coffee spout but
around the edges of
the service door.
No milk comes out
of the milk frothing
spout.
The milk is not
properly frothed.
The milk contains
bubbles or squirts
out of the milk
frothing spout.
Some water is spilled
when I place or
remove the water
tank.
4222.002.6507.7.indd 31
All manuals and user guides at all-guides.com
Possible cause
You have put too much
ground coffee in the ground
coffee compartment.
You have not selected the
ground coffee function.
As a result, the appliance
has become blocked
because it has tried to brew
coffee using both the pre-
ground coffee and the coffee
from its own grinder.
You have put ground
coffee in the ground coffee
compartment while the
appliance was switched off.
The spout holes are clogged
with dried coffee residues.
The slide-out tray inside the
service door is blocked and
cannot slide in and out of
the service door.
The milk intake tube is not
inserted or not properly
inserted into the milk jug lid.
The milk jug lid is dirty.
The milk jug is not placed
correctly.
The milk is not cold enough
or you have not used
skimmed or semi-skimmed
milk.
It is normal that some water
is spilled when you place and
remove the water tank.
Solution
Switch off the appliance and remove the
brewing unit and thoroughly clean the inside
of the appliance. Brew espresso from ground
coffee again, but do not put more than one level
spoonful of ground coffee in the ground coffee
compartment
Switch off the appliance and thoroughly clean
the inside of the appliance. Brew espresso from
ground coffee again, but make sure you select the
ground coffee function.
Thoroughly clean the inside of the appliance.
Brew espresso from ground coffee again, but
switch on the appliance before you put the
ground coffee in the ground coffee compartment.
Scrape the dried coffee residues out of the spout
holes with a needle.
Thoroughly clean the slide-out tray, particularly
near the hinges to ensure that it slides smoothly
in and out of the service door.
Insert the milk intake tube in the rubber ring in
the milk jug lid.
Clean the milk jug lid.
Clean the nozzle for the milk jug.
Place the milk jug correctly into the appliance.
Use skimmed or semi-skimmed milk at
refrigerator temperature. If you still do not
get the desired result, try a different milk brand.
The spilled water automatically flows into the
drip tray.
EnglisH
31
31-08-09 17:46