Platinum JSS-27501 Manuel D'instructions page 5

ENGLISH
USING YOUR HUMIDIFIER
1. Carefully remove your humidifier from the carton, and take off all the protective
wrapping.
2. Place the humidifier on a firm, level surface free from obstructions.
3. For first using, please put the humidifier in a room with normal temperature. After half
an hour, it can be operated.
4. Working temperature: 5℃-40 , relative humidity: ≤80%RH
5. Using water less than 40
6. Turn over the water tank and unscrew the water tank cap at the bottom of the tank by
turning it counterclockwise. Fill water tank with cold water; Replace the water tank cap,
aligning the threads on the tank with the threads on the cap, and turn it clockwise. Turn
the tank over, holding one hand by the top handle and another hand under tank. Place
full water tank on the central body, making sure it fits perfectly. Place the water tank lid
with output slot on top of the water tank. (The appliance must be unplugged before
either filling or emptying）.
7. Put the nozzle in the notch of water tank and adjust the nozzle away from walls and
furniture.
TO USE YOUR HUMIDIFIER
1. Plug the humidifier into a power outlet.
2. Turn the power and mist control knob clockwise to turn on the humidifier (never switch it
on without water), and also can use this knob to select your desired mist volume
(clockwise to increase and the anticlockwise to decrease )
3. Press the button Heat, you can enjoy the warm mist, more clean and increase the
quantity of humidifying.
4. Aroma oil filling: If you want the mist coming out with good smell you can add some
Aroma which you desired in the Aroma oil holder as following: Open the inlet grid, pull
out the Aroma oil holder, fill the Aroma oil, install the holder back to the unit base then
install the inlet grid.
Note: It is normal if there is a little of mist overflows from the nozzle at the beginning of
working.
(purified water is recommended).