Télécharger Imprimer la page

American Comfort Worldwide ACW0035 Manuel Du Propriétaire page 6

Publicité

Visually inspect the heater before operation. Do not operate the heater if any damages are detected.
Contact our customer service center immediately.
NOTE: " " and " " buttons both on the control panel and remote control.
1) Plug the power cord directly into a conventional 120V 15 amp outlet and press the MASTER POWER
switch on the rear of the heater. Then press the " " button on the front control panel or on the
remote to start the unit. The LED display will show the default value as 72°F /22°C. By pressing the"
" or " " button, you will choose the desire temperature. The temperature range you can set on this
heater is 50°F / 10°C ~ 86°F / 30°C.
2) By pressing both the " " and " " button on the front control panel or the " " button on the
remote control, you can switch the temperature format between Fahrenheit and Celsius.
3) By pressing the " " button, the LED display will switch from the temperature setting to the timer
setting and begin to blink the default timer "--", and that means that the TIMER is not activated and
the heater will work all the time. If you press the " " button again, the screen will display "2", that
is 2 hours. The timer will increase 2 hours on each pressing the " " button. The maximum timer is
12 hours. When it reaches 12 hours, the screen will return to "--" and you will restart the setting on
timer. If you do not press " " and " " within (5) seconds after you set the TIMER, the time status
will switch back to the temperature status.
4) The heater will turn off by pressing the " " button on the front control panel.
DO NOT TURN OFF THE MASTER POWER SWITCH ON THE REAR OF THE HEATER OR
UNPLUG THE HEATER UNTIL THE FAN SHUTS DOWN. If the heater is still in the TIMER function,
there will be (5) seconds sound alert to let you know that the timer is invalid. If no actions are taken,
the heater will shut off.
All manuals and user guides at all-guides.com
Operating Instructions
Function Display
Press the buttons "
"
" on the control panel at
the same time
5 seconds later the value
switches to ambient
temperature
" and
5

Publicité

loading