Audiovox Professional Serie Manuel D'instructions page 2

All manuals and user guides at all-guides.com
YOUR KEYCHAIN TRANSMITTERS:
The transmitters included with this security system are pre-programmed at the factory,
with button assignments (channels) prioritized in a standard format. You can select which
transmitter button controls a particular function, (see the transmitter programming guide).
This manual explains the operation of the system assuming that the transmitter buttons are
prioritized in their standard, factory pre-set format.
ARMING THE SYSTEM (CHANNEL 1) :
1. Turn off the engine, exit the vehicle, and close and lock all doors, hood, and trunk.
2. Press and release button #1 on the keychain transmitter. The siren will "chirp" once,
the vehicle's parking lights will flash once, the doors will lock (optional), and the dash
mounted L.E.D. will begin to slowly flash.
WARNING! Excessive pressure on the transmitter buttons will damage the
internal components on the circuit board. All that is required is a light push to the
button.
NOTE: If the siren "chirped" three times when ARMING, then one of the entry points
(hood, trunk, doors) has been left opened. Closing the hood, trunk, or doors will correct
the problem, and you do not need to disarm the system to make the correction.
ARMING THE SYSTEM (CHANNEL 1) :
1. Turn off the engine, exit the vehicle, and close and lock all doors, hood, and trunk.
2. The dash mounted L.E.D. will begin to flash rapidly, indicating that the system is
automatically (passive) arming. As an added convenience, the automatic passive
arming will not begin until all doors and trunk lid are closed, allowing passengers to
exit the vehicle at their convenience.
3. In 30 seconds, you will hear a single short "chirp" from the siren, and the vehicle's
parking lamps will flash one time, indicating the system is ARMED. At this time, the
dash mounted L.E.D. will begin to flash slowly, providing a visual indication that the
system is fully ARMED.
OPTION NOTE: If the optional (not included) power door lock interface has been
installed, the alarm control module can be programmed to...
a) Automatically lock the doors during step 3 above or,
b) Only lock the doors when step 4 below is executed.
4. If you wish to arm the system immediately, simply press and release button #1 on the
keychain transmitter. The siren will "chirp" once, the vehicle's parking lamps will flash
once, the doors will lock, and the dash mounted L.E.D. will begin to slowly flash.
ACTIVE
PASSIVE
Page 2