PRIXTON MARCONI Mode D'emploi page 6

Set-up : Place your turntable in a secure location where it will be protected from the
elements or possible falls.
Power connection: Connect the power by 5V DC adaptar.
Lift the dust cover: Lift the dust cover and keep it open when in use.
Turn on: Turn on the Power Switch, note that this also controls volume.
Speed selection: Select the speed between 33, 45 and 78 rpm through speed switch.
Insert the record: Carefully remove the record from its case and place the record on the
turntable plate.
Move the needle: Release the tone arm lock, slowly and gently move the needle over the
record, placing it on the outermost part of the record.
Drop the needle: Once the needle is over the record, use the small lever on the base of the
needle and press down to lower it onto the record.
Enjoy your music: Once above steps are completed, press the "Play mode" select key the
turntable will start turning automatically.
Finishing up: Lift up the tone arm and put it on the rest when finished, turn off the Power
Switch. (the turntable will stop automatically if the auto-stop switch is in the ON position. lf
the switch is in the OFF position then it will keep revolving until the tone arm is moved.)
Connecting to an external sound system: Connect an RCA audio cable (not supplied) to
the AUDIO LINE OUT sockets on the rear of the turntable. Connect the other end of the
cable toan AUDIO INPUT on the amplifier. Red plug into R channel output. White plug into
L channel output.
USB/TF function: (lift up the tone arm and put it on the rest) lnsert your USB disk or TF
card. Wait for few second, USB or TF music will begin. Under this function, other functions
will stop automatically.
USB/TF recording: lnsert the TF card or USB stick and hold down the "M" key until "REC"
appears on the screen, then press the "PLAY/PAUSE" key to start recording. To stop
recording press the "M" button.
Bluetooth transmitter function: Press the "M" button twice to enter into Bluetooth
transmitter function. Make other Bluetooth speaker in BT mode. Devise and other BT
speaker will pair automatically. There four audio sources can be transmitted, USB/TF/AUX
IN/PHONO.
Note:
When you want to play your vinyl through an external bluetooth speaker, please note that
it does not allow for device selection. Therefore, make sure that all surrounding Bluetooth
devices are turned off and only the one you want to connect to is turned on. After the first
connection, the turntable will automatically connect to the previously connected speaker
the next few times.
FM function: (Lift up the tone arm and put it on the rest) Press "M" key to select FM mode.
Clear recorder music: When you want to clear the recorder music, press and hold the
"PLAY/PAUSE" button till display"DEL" and click the "PLAY/PAUSE" button once again to
confirm, the currently playing music will be removed.
Aux in function: (Lift up the tone arm and put it on the rest) Insert Aux in cable (Please
note other functions will not work while cable is inserted).
Replacing the stylus needle: Push back the arm lock to release the tone arm. Unclip and
remove the stylus needle from the cartridge then replace with a new one.
Installing a new stylus cartridge: Note: Please exercise extreme care whilst performing
this operation so as to avoid the tone arm and audio line wires from any damage.
Gently unclip the cartridge from the tone arm. Gently pull out the audio wires attached to
the cartridge. Replace with a new cartridge, please ensure audio wires are fitted securely
then clip back on to the tone arm.
6