Intex 12700 Mode D'emploi page 57

LED Reading
E81 Transmission signal failure
E90 No water fl ow
E94 Water temperature too low
E95 Water temperature too high
E96
E97 Dry-fi re Protection
E99 Water temperature sensor broken • Contact Intex Service Center.
After 72 hours of continuous
heating operation, the pump will
END
hibernate automatically. The rapid
heating function is disabled.
Control panel battery has no power
or in "Power Saving Mode" waiting
BLANK
to be placed on the control base
charging dock.
S AVE THESE INSTRUCTIONS
LED CODE CHART
CAUSE
• Reset the RCD, restart all over again.
• Place the control panel within 5 m (16 ft) of the
control base unit.
• Press and hold POWER button for 5 seconds to
turn off and charge the panel again.
• If problem persists, contact Intex Service Center.
• Turn off and unplug the control unit.
• Ensure the outlet cover grid is clean and free from
obstructions.
• Clean or replace the cartridge, see Maintenance
and Storage section.
• Ensure the in/outlet connections on the spa tub and
fi lter pump are not blocked.
• Keep the spa water properly sanitized to ensure a
clean and unclogged fi lter cartridge.
• If problem persists, contact Intex Service Center.
• If the ambient temperature is below 4°C (39°F), we
recommend not to use the spa.
• Turn off and unplug the control unit, add some
warm water to raise the spa water temperature
above 5°C (41°F), then press the
up the water to the desired temperature.
• If problem persists, contact Intex Service center.
• Turn off and unplug the control unit. When the water
has cooled down, plug the RCD and restart all over
again.
• Turn the heater off , then press the fi lter and bubble
buttons to lower the water temperature.
• If problem persists, contact Intex Service Center.
• Turn off and unplug the control unit. Plug the RCD
System Error and restart all over again.
• If problem persists, contact Intex Service Center.
• Contact Intex Service Center.
• Press the
• Press any button to reactivate the control panel.
• Reset the RCD, restart all over again and charge
the control panel again.
• Make sure the surface between the back of the
control panel and the control base charging dock is
clean, dry and free of obstruction.
• If problem persists, contact Intex Service Center.
(352IO) SPA ENGLISH 7.5" X 10.3" PANTONE 295U 09/18/2020
SOLUTION
button to re-active the fi lter pump.
352
English
A
button to heat
Page 21