Intex 12700 Mode D'emploi page 46

Additional requirements for indoor installation
• Make sure the fl oor can support the full weight of the fi lled spa with the maximum number of occupants.
Check with a qualifi ed contractor or a structural engineer to verify this requirement.
• Make sure the fl oor is water resistant and non-slip surface. Do not install the spa on carpet or other
materials that will be damaged by moisture, condensation.
• Do not install the spa indoors on a second fl oor above fi nished living space due to the possibility of water
and humidity damage.
• Humidity is a natural side eff ect of indoor spa installation. The room shall be properly ventilated to allow
moisture to escape. Install a ventilating system to prevent excess condensation, moisture in the room.
Additional requirements for outdoor installation
• Spa owners may need to comply with local or states laws relating to childproof fencing, safety barriers,
lighting, and other safety requirements. Contact your local building code enforcement offi ce for further
details.
• Make sure the surface is level, fl at, smooth and strong enough to support the full weight of the fi lled spa.
• Do not setup the spa on grass or dirt, as this increases the amount of debris entering the spa, and
damage the spa fl oor.
• Do not expose the spa to direct sunlight for extended period of time. Provide protection from the
sun such as sunshade, tent, awning or gazebo.
• It is possible to install and leave the spa outside at a temperature not lower than 4°C (39°F) provided the
water temperature inside the spa is higher than 4°C (39°F) and the water inside the circulation system,
pump, pipe are not frozen. Put a "temp barrier mat" between the spa fl oor and the ground to prevent heat
loss from the bottom of the spa and to provide better heat retention. Do not use the spa if the ambient or
water temperature is 4°C (39°F) or lower.
Setup the spa with at least 2 persons.
1. Move the entire package to the selected site. Do not drag the spa tub across the ground as this can
cause damage and leakage.
Open the carton carefully as this carton can be used to store the spa during long term storage or when
not in use.
2. Lay out all the parts on the ground and make sure all the parts are accounted for. For missing or
damaged parts contact the appropriate Intex Service Center listed in the separate "Authorized service
Centers" sheet.
Spa Control Panel Charging and Installation
1. Make sure the back of the control panel (5) and the control base charging dock surface are clean and
dry.
2. Make sure the control base is plugged in and the RCD tested. Place the control panel (5) on the control
base charging dock to charge the built-in battery (see drawing 1). See "Spa Control Panel" operation
section for more details.
3. It takes approximately 3 hours to fully charge the control panel battery. Once the control panel battery is
fully charged, you may place the control panel on top of the spa tub wall (see drawing 2.1). To remove
the control panel from the spa tub, lift the latch while pulling the control panel away from the support
stand (see drawing 2.2).
S AVE THESE INSTRUCTIONS
SET UP (continued)
1
5
5
(352IO) SPA ENGLISH 7.5" X 10.3" PANTONE 295U 09/18/2020
2.1
1
352
English
A
2.2
2
Page 10