Publicité
Les langues disponibles
Les langues disponibles
3.2
Remote Control: memorization of the codes
The control unit dispose of P1 button to memorize the codes. If you memorize a SmILE-C make sure that all buttons has
a code otherwise it need to be generated. In case you want to memorize a SmILE-H (rolling code remote control) you
don't need to generate any code. All outputs should be deactivated, all lights should be turn off. LED L1 should flash
constantly (see Activation of the codes in the following chapter) .
memorize the first channel of the remote control for the LIGHT GROUP no.1
1
Press and release BUTTON P1 in the control unit, LED L1 will lit for 6 seconds.
Press in 6 seconds time the button of the remote control (we suggest the first channel).
2
To confirm the operation LED L1 will flash 5 times. The code has been memorized.
memorize the first channel of the remote control for the LIGHT GROUP no.2
1
Press and release BUTTON P1 in the control unit, LED L1 will lit for 6 seconds.
2
In 6 seconds press and release BUTTON P1 again, LED L1 will lit on for 6 seconds. Then
Press in 6 seconds time the button of the remote control (we suggest the second channel) .
3
To confirm the operation LED L1 will flash 5 times. The code has been memorized.
memorize the first channel of the remote control for the LIGHT GROUP no.3
1
Press and release BUTTON P1, LED L1 will lit on for 6 seconds. Then
2
In 6 seconds press and release BUTTON P1 again, LED L1 will lit on for 6 seconds. Then
3
In 6 seconds press and release BUTTON P1 again, LED L1 will lit on for 6 seconds. Then
Press in 6 seconds time the button of the remote control (we suggest the third channel) .
4
To confirm the operation LED L1 will flash 5 times. The code has been memorized.
If LED L1 should flash slowly it means that the memory is full and it cannot accept any other command. In case of 20bit
remote control the memory capacity is of 22 different codes if you need more capacity connect an extra receiver like RX2
-RX4 with capacity from 200 codes up to 3000 codes.
If you are not sure of that operation , start from point 1 again but before reset the memory of the receiver.
Read the previous chapter "Cancellation of the memory"
All manuals and user guides at all-guides.com
5
Publicité
