oventrop Datalog CS-BS-1 WLAN Instructions D'installation Et D'utilisation page 40

7.7 Displaying WLAN connection information
In order to display the WLAN connection information, proceed as follows:
Î Click the Status main menu.
The following information will be displayed in WLAN:
• Network name (SSID)
• Signal strength (for more information on signal strength, see chap. 7.15 on page
35).
• Encryption
• Channel
• IP address
• MAC address
Note
If a WLAN connection has been established, it will use the MAC address
of the access point. The access point will receive a new address. If the
WLAN is disconnected, the access point will use its original MAC address.
7.8 Displaying access point information
In order to display access point information, proceed as follows:
Î Click the Status main menu.
The following information will be displayed in Access point:
• Network name (SSID)
• Encryption
• MAC address
• Channel
7.9 Changing the Web interface language
The Web interface can be run in different languages.
Î Click one of the small flags on the Home screen, according to the desired
language:
• Deutsch
• English
• French
• Spanish
• Italian
All manuals and user guides at all-guides.com
The language has been changed for this session. In order to select a language for
future sessions, proceed as follows:
Î In the Configuration main menu, select the General submenu.
Î On the General Configuration tab, in the Language dropdown menu,
• German (de)
• English (en)
• French (fr)
• Spanish (es)
• Italian (it)
Î Click Save configuration.
7.10 Configuring the user mode
The user mode of the Web interface can be changed from standard user to expert
and vice versa. In the expert mode, additional information and settings will be avail-
able, such as: LAN configuration, LAN information, firmware updates, etc.
In order to adjust the user mode, proceed as follows:
Î In the Configuration main menu, select the General submenu.
Î In order to activate the expert mode, select Yes in the Expert mode menu. In
Î Click Save configuration.
7.11 Changing the device name
In order to change the device name, proceed as follows:
Î In the Configuration main menu, select the General submenu.
Î On the General Configuration tab, enter the device name in the Device
Permitted characters are: letters, numbers, underscores, hyphens.
Special characters are not allowed.
Î Click Save configuration.
select one of the following languages:
order to deactivate the expert mode, select No.
Note
Choose a descriptive device name to facilitate identifying the Datalog CS-
BS-1 WLAN in the network.
name field.
33