Tylo Elite Mode D'emploi page 9

EN
All manuals and user guides at all-guides.com
Installation Guide
The control panel can be installed inside or outside the sauna/steam room. If installing inside
the sauna cabin, the upper edge must not be more than 90 cm above the floor, and must be at
least 30 cm from the heater.
The unit can be mounted on the wall using the bracket or double-sided adhesive supplied. If
using the bracket, mount the control panel on the bracket using adhesive.
A 30 mm hole through the wall is required if mounting the control panel directly on the wall.
When installing the panel inside the steam room/sauna, installation must be directly to the wall,
using the accompanying adhesive or a Tylö embedding frame (item no. 90001056). The wall
must be smooth and perfectly clean after hole drilling (30 mm) before installation. The bracket
must not be used.
If you have purchased an Elite check the coverage of your wireless network before you finally
install the control panel (see also Configuring: System settings in this guide).
Installation with bracket
Use the bracket as a template to mark up screw holes on the wall. Tighten the screws a little
until the bracket is loosely secured.
Secure the adhesive to the bracket (see Figure 1).
Fig. 1
Remove the protection from the adhesive and secure the panel to the bracket (see Figure 2).
Fig. 2
9