Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
HEATER LOCATION
When choosing a location for your new heater,
ensure that the general instructions are followed.
Also, for best effect, install the heater out of direct
sunlight.
Cold climate installation recommendation:
when installing this unit against a
non-insulated exterior wall or chase, it is
mandatory that the outer walls be insulated
to conform to applicable insulation codes.
ELECTRICAL CONNECTION
A 15 AMP, 120 Volt, 60 Hz circuit with a properly
grounded outlet is required. Preferably, the
heater will be on a dedicated circuit as other
appliances on the same circuit may cause the circuit
breaker to trip or the fuse to blow when the heater is
in operation. The unit comes standard with 6 feet
(1.8 m) three wire cord, exiting from the rear of the
heater.
CAUTION: Do not exceed the current rating of the
current tap.
Always plug heaters directly into a wall
outlet/ receptacle. Never use with an extension cord or
relocatable power tap (outlet/ power strip).
ELECTRICAL SPECIFICATIONS
Voltage:
Amps:
Amps:
Watts:
Watts:
WARNING: Make sure the power is turned off before proceeding. Any electrical repairs or
WARNING: Make sure the power is turned off before proceeding. Any electrical repairs or
rewiring of this unit should be carried out by a licensed electrician in accordance with
rewiring of this unit should be carried out by a licensed electrician in accordance with
national and local codes.
national and local codes.
If repairing or replacing any electrical component or wiring, the original wire routing, color
If repairing or replacing any electrical component or wiring, the original wire routing, color
coding and securing locations must be followed.
coding and securing locations must be followed.
WARNING: Electrical outlet wiring must comply with local building codes and other applicable
WARNING: Electrical outlet wiring must comply with local building codes and other applicable
regulations to reduce the risk of fire, electrical shock and injury to persons.
regulations to reduce the risk of fire, electrical shock and injury to persons.
WARNING: Do not use this heater if any part of it has been under water. Immediately call a
WARNING: Do not use this heater if any part of it has been under water. Immediately call a
qualified service technician to inspect the heater and replace any part of the electrical system.
qualified service technician to inspect the heater and replace any part of the electrical system.
Warning: Disconnect power before attempting any maintenance or cleaning to reduce the risk
Warning: Disconnect power before attempting any maintenance or cleaning to reduce the risk
of fire, electrical shock or personal injury.
of fire, electrical shock or personal injury.
Warning: During any service of this appliance, the power to the unit must be turned off.
First turn the main power switch to the "OFF" position. Then remove the electrical plug from
the wall outlet.
120 V~, 60Hz
12.5 Amps (with heater)
< 0.1 Amps (without heater)
1500 Watts (with heater)
< 10 Watts (without heater)
MAINTENANCE
CLEARANCE TO COMBUSTIBLES
Keep electrical cords, drapery, furniture and other
combustibles at least 3 feet (0.9 m) from the front of the
heater and away from the sides.
CLEANING TRIM
Clean the trim using a soft cloth, slightly
dampened with citrus oil based product and buff with
a clean soft cloth. DO NOT use brass polish or
household cleaners as these products will damage
the metal trim. Citrus oil based products can be
obtained at supermarkets or hardware stores.
Periodic cleaning/vacuuming of the filter is recommended.
Make sure the unit is turned OFF and unplugged
whenever you are cleaning the heater.
Figure 3
Filter
Filter Cover
Publicité
Table des Matières
