Publicité
Les langues disponibles
Les langues disponibles
Making the Connections
Now the location has been decided, connect the sources to the ASB-10 ensuring that none of the cables are not
kinked or stretched.
NOTE: Do not connect the power to the ABS-1 until you have made all of your audio/ video connections.
Connecting Audio Devices Via Digital Input
You can connect the device to the ASB-10 using the Digital Optical or Digital Coaxial outputs from them.
Connecting Analogue Audio Devices Via Coaxial Input
You can connect to the ASB-10 using analogue audio source using a 3.5mm mini jack lead.
Subwoofer Output
To get extra bass from the ASB-10 it has a subwoofer output facility on it. The subwoofer must be purchased
seperately. Simply use a coaxial subwoofer lead to connect from the subwoofer output on the ASB-10 to the LFE
input of the subwoofer. Refer to page 17 for details on the sub woofer settings.
Connecting the Power
Now that all of the signal cables are connected, it is now time to connect the power.
IMPORTANT: Please follow the following instructions in sequence.
1. Connect the mains lead to the ASB-10 (leaving the switch in the off position).
2. Connect to wall socket and where applicable turn on.
3. Turn the mains power switch on the side of the amp panel to the on position. The ASB-10 will power on
straight away. The standby button will illuminate white and the LED on the front will flash blue as it goes
through the initial start up process and then slowly flash blue until it is connected to a wireless network or the
input changed.
All manuals and user guides at all-guides.com
5
Publicité
