JUST ONE HELMET J12 Mode D'emploi page 29

USER'S INSTRUCTIONS All manuals and user guides at all-guides.com
EN
If after repeating the test you are not able to efficiently tighten the retention system, do not use the helmet.
Only after checking the correct tension of the strap, fix the free end locking it with the automatic stud to the release
tab (see fig. 2).
The automatic stud is necessary only to fix the free end of the strap to prevent it from flapping while riding. Fixing
the release button does not assure that the helmet is correctly in position and properly fastened: the correct lo-
cking of the strap must be verified exclusively following the above paragraphs.
To release the retention system, release the automatic stud button and pull the release tab to loosen the closure. Slide
out the free end of the strap from the "D-Rings".
Use the release tab only to remove the helmet! Never release this tab while riding.
If the retention system does not work properly, do not use the helmet and contact JUST 1 Helmets authorized
personnel only.
The part in fabric is attached with Velcro and can be washed and replaced.
To remove it, release the Velcro and slid it out from the free side.
To fasten again, slide back in the fabric from the free side and fix the fabric to the Velcro again.
j U S T O N E H E L m E T S . C O m
24