Axis Washer Kit B Guide D'installation page 14

AXIS Washer Kit B
Connect the I/O-cable
1
CP
2
GCP
1. Connect the I/O-cable to the J9 control terminal according to the table.
Note
All connections of terminal J9 must have a very low safety voltage.
2. Make sure the I/O-cable is connected to the pins on the I/O-connector according to
the table.
Description
Pump control
GND (pump control)
3. Connect the I/O-connector to your compatible Axis product. For information refer to
the installation guide of that Axis product.
Note
The I/O-connector is not included in the kit.
All manuals and user guides at all-guides.com
J9 control terminal
CP
GCP
I/O-connector pin
Pin 3–6 (digital output)
Pin 1 (DC-ground)
14