Electrical Connection - Proficook PC-DKI 1067 Mode D'emploi

Do not use the following types of pots :
Pots with Pots with a
bended base diameter
(convex/para- of less than
bolic) bases. 12 cm.

Electrical Connection

Connected load/wattage
The hob can take up an overall load of 3500 W.
Because of this high connected load it is recom-
mended to use a separate connection protected
over a 16 A safety switch.
CAUTION: OVERLOAD!
Do not use extension cables or multiple sockets
as the power consumption of this device is too
high for these.
Connection
• Before inserting the mains plug into the socket
check whether the voltage which you intend to
use corresponds to that of the machine. Please
see the label on the machine for details.
• Only connect the machine to a correctly in-
stalled safety socket.
Operation
• The appliance has a fine sensor. A light touch
of the control panel with the finger is sufficient.
Use the finger, not the tip of the finger.
• Each registered touch is confirmed by a beep.
• In the event that the appliance does not react
when you press the buttons, clean the control
panel with a soft, dry cloth. Even a thin film of
water can make the operation difficult.
• Ensure that the control panel is always clean
and dry and that it is not covered by objects of
any kind.
Standby mode
After you have connected the device's plug to the
mains supply, the hub is in standby mode. A signal
will sound.
• Put a suitable pot on the cooking zone.
• Press the ON/OFF button to start cooking. The
Pots stand-
indicator light above the ON/OFF button lights
ing on feet.
up. The indicator light for POWER above the
SELECT button will flash.
NOTE:
You must now press the SELECT button
within 60 seconds, or the hotplate will switch
back to the operating mode of standby.
Selecting performance, shut-off time or tem-
perature as the function
Press the SELECT button to select the control by
power, shut-off time or temperature. The indica-
tor lights POWER, TEMP. and TIME will show the
selection.
Selecting the power or temperature of the
hotplate
• Use the UP or DOWN buttons to select a tem-
perature level between 60 °C and 240 °C or
one of the 6 power settings:
Left cooking hob 500/800/1200/1500/1800/
2000 W
Right cooking hob 500/800/1000/1200/1300/
1500 W
• Use the MAX or MIN buttons to directly select
the highest or lowest power setting respectively.
The display will show the max. or min. power
setting.
NOTE:
• The temperature setting changes in inter-
• The left cooking hob always starts at
• The right cooking hob always starts at
vals of 20°.
1200 W or a temperature setting of
240 °C.
1000 W or a temperature setting of
240 °C.
53