Publicité
GB
1. Mounting the rear wheels
Place the body with the underside facing up. Slide a rear wheel (2) onto the rear axle.
Next, slide a washer (11) onto the axle and fix this with a nut (10). Finally, place a hub cap
on the wheel and fix it by pressing it firmly. Repeat this process on the other side.
2. Mounting the front wheels
First slide a washer (12) onto the axle and then the wheel (2). Fix the whole thing with another
washer (11) and a nut (10). Finally, place a hub cap on the wheel and fix it by pressing it firmly.
Repeat this process on the other side.
3. Battery connection
Insert the battery into the battery adapter located under the seat. To remove the battery, push
the red lever at the top of the battery and pull it out. Please use only batteries of the original
Power-X-Change series, 18 V, from EINHELL.
Attention!
Do not attempt to force the battery out. Otherwise the model would be damaged.
4. Mounting the Steering wheel
Connect the cable from the steering wheel (3) to the cable from the model.Test the music
buttons to make sure the connection works. Place the steering wheel in its designated position
(correct position, horn on the right, music button on the left). Align the hole through which the
screw (13) comes. Insert the bolt and tighten it with a nut (9).
5. Assembling the seat
Place the seat (6) on the designated position and fix it with the designated screws (14)
as shown in the figure.
6. Mounting the Windshield
Push the Windshield (4) into the designated position until it clicks in position.
7. Fitting the rear-view mirror
Push the rear-view mirrors (5) into position until they click in position.
5
a
b
1
1
Problem
No function
Can be switched on but does not drive.
Can be switched on but does notmove, or only direction.
Can be switched on but only travels in one direction
The active fuse blows and switches the unit off for a few seconds. You will
hear a single click at the beginning
No sound function on the steering wheel/andlebar
Vehicle has very high wear on switches.
The rubber tyres come loose on the wheels
Wheel keeps falling off the axle.
The safety instructions for using and charging the Power-X-Change 18V batteries from EINHELL can be found in the
instructions for your original EINHELL product.
8
6
2
3
4
5
Source
Battery is not or incorrectly connected.
ON/OFF switch defective.
Motor cable incorrectly connected or not connected.
Gas or direction switch defective.
Directional switch defective.
Oberload or electrical short circuit.
the cable was torn or crushed during assembly.
Dirt and moisture damage the switches.
Ridden on too hot a surface or in dirt.
Mounted incorrectly.
8. Charging
To charge the battery, remove it from the model. To charge the battery, follow the battery
manufacturer's instructions (EINHELL).
Important:
The battery must be removed after using the vehicle to avoid self-discharge or deep
discharge!
Warning!
•
The charger is not a toy. Only use the charger supplied.
•
The battery may only be charged by or under the supervision of an adult.
•
The terminals must not be short-circuited.
•
The charger must be checked regularly for damage to the cable, plug, housing and other
parts. If any damage is found, the charger must not be used until the damage has been
repaired.
• Let the model cool off sufficiently after each use before putting it back into operation.
When using an additional batteries let it cool off for minimum 15 minutes until the
model is operated again. Overheating can damage the electronics or may result in fire.
• Always disconnect the model from the charger immediately after charging. Always
disconnect the charger from the power supply immediately after disconnecting the
model. Inserting the rechargeable model or charger after charging will result in damage
tothe model, charger or the power supply (fire hazard).
• Use the charger only in dry rooms.
Functions
1 Soundboard
2 Shift Lever:
2
Forward▲:
Press the shift lever on the „Forward ▲" position.
Press the foot pedal, the model drives forward.
Stop O:
The model will brake automatically, when your child's foot remove from the
foot pedal. Press the shift lever in the middle.
Reverse▼:
Press the shift lever on the „Backward▼" position.
Press the foot pedal, the model drives backwards.
Important!
The vehicle must be stationary before changing direction. Otherwise the gear unit and/or
the motor could be damaged.
3 ON/OFF Switch
With the ON/OFF switch you start the vehicle.
4 Foot pedal
3
5 Steering wheel
a Music
b Music
4
Soundboard
1
USB
2
Bluetooth/Music
By pressing the button shortly Bluetooth will turn on.
By pressing the button shortly again music will start to play.
3
Song button
4
Music/V-
Press = previous, long press = Volume down
5
Music/V+
Press = Next, long press = Volume up
6
Voltage display
Solution
Connect the battery (see instructions)
Check or replace switch.
Check and connect motor cable (see instructions).
Check or replace switch.
Check or replace switch.
Do not overload or have the until checked.
Check or replace the steering wheel.
Do not drive in moisture or dirt such as meadows, gavel, sand, etc.
Change tyres and avoid hot surfaces and dirt.
Check that the wheel is properly engaged (see instructions).
8
Publicité
