Fanelite LF42-40R-DC Mode D'emploi page 24

4. ASSEMBLY
WARNING : Before assembling your appliance, carefully read the
safety instructions in this manual.
Remove the base/tube assembly mechanism (15) from the tube (13);
turn counterclockwise. Insert the tube (11 to 13) into the center of the
base (14) and replace the base/tube assembly mechanism (15) to
secure the assembly of the tube and the base (11 to 15); turn
clockwise.
Position the motor block/control panel assembly (6 to 10) correctly on
the extendable tube (11) and tighten the tube fixing screw (10) to
secure the assembly (6 to 15); turn clockwise. If necessary, first loosen
the height adjustment ring (12) by turning counterclockwise in order to
be able to adjust the height of the extendable tube (11) then tighten the
ring by turning clockwise.
Remove the blade locking nut (2) from the motor shaft (6) by turning
clockwise as well as the rear grille locking ring (4) from the motor block
(7) by turning counterclockwise. Correctly place the rear grille (5) on
the motor block (7) then replace and tighten the rear grille locking ring
(4) on the motor block (7) by turning clockwise. Insert the blade (3) onto
the motor shaft (6) until it locks. Replace and tighten the blade locking
nut (2) onto the motor shaft (6) by turning counterclockwise. Take care
to tighten the nut correctly. Check that the blade turns well by turning it
manually.
Correctly position the front grille (1) on the rear grille (5) then assemble
the two grilles using the locking clips. Then tighten the screw provided
to secure the assembly.
5. OPERATING INSTRUCTIONS
WARNING : Before using your appliance, carefully read the safety
instructions in this manual.
Plug in the power cord. Using the control panel or the remote control
(insert batteries first ; see section Replacing the batteries):
24