auronic AU3100 Manuel D'utilisation page 21

Emptying the dust container
Keep in mind that dust is released during these steps. Wear a nose and mouth
mask if you are sensitive to dust.
Perform these steps over a container or trash can.
1. Press the handle lock button and remove the handle from the dust container.
2. Open the dust container at the front and empty it over a container or trash can.
MAINTENANCE AND CLEANING
Clean the outside of the product with a damp, clean cloth and dry it thoroughly. Do not use
abrasive or aggressive cleaning agents. Empty the dust container regularly. Clean the HEPA fi lter
regularly and replace it every 4-5 months.
Cleaning the HEPA fi lter
Keep in mind that dust may be released during these steps. Wear a nose and
mouth mask if you are sensitive to dust.
1. Press the battery lock button and disconnect the battery from the dust container.
2. Open the dust container and remove the dust cup.
3. Remove the fi lter housing from the dust cup. Remove the fi lter from the fi lter housing by
gently pulling it out with a twisting motion.
4. Wash the fi lter and fi lter housing with clean water. You can soak it in a bowl of water or hold
it under the tap.
5. Allow the fi lter and fi lter housing to dry completely before reinserting it for use.
6. After drying, place the fi lter back into the fi lter housing with a twisting motion. Then place
the fi lter housing into the dust cup. Make sure that the fi lter and fi lter housing are properly
seated in the dust cup.
English
21