Publicité
Les langues disponibles
Les langues disponibles
LOCATION OF PARTS AND CONTROLS
LED RING
ON/0FF
HOT SURFACE
INDICATOR
SET UP INSTRUCTIONS
1. Open the lid and remove any packaging contents.
2. Place the towel warmer on a hard, level, dry surface.
3. Insert the plug into a standard 120V outlet.
08
HOW TO USE
1. Insert the power cord into an electrical outlet.
2 Open the lid and place only dry towel(s), a bathrobe, or blanket inside.
CAUTION: Placing damp or wet towels inside the towel warmer can damage
the unit and pose serious safety risks.
3. Close the lid.
4. Press the on/off button. The LED ring will tum red, indicating that the unit
is heating.
5. When the temperature of the interior surface exceeds 122
surface indicator will light up. When lit, the interior surface of the towel
HANDLE
warmer is unsafe to touch.
6. 15 minutes is typically sufficient for heating 2 bath towels up to 45" X 70"
LID
each.
NOTE: The towel warmer could reach approximately 266
remain hot for the duration of the heating cycle.
7. Open the lid to remove the towel(s), bathrobe, or blanket.
POWER
CORD
NOTE: To avoid damage to the unit, gently raise the lid when removing
items.
8. Press the on/off button at any time to stop or start the heating cycle.
9. The unit will automatically tum off after 60 minutes.
10. After the heating cycle is complete, the interior surface of the towel
warmer will remain dangerous to touch until the hot surface indicator turns
off.
F/50
C, the hot
O
O
F/130
C and
O
O
09
Publicité
