Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
with the application of the relevant safety regulations and
the implementation of safety devices, certain residual risks
can not be avoided. These include:
•
Injuries caused by touching any rotating/moving parts.
•
Injuries caused when changing any parts, blades or
accessories.
•
Injuries caused by prolonged use of a tool. When using
any tool for prolonged periods ensure you take regular
breaks.
•
Impairment of hearing.
•
Health hazards caused by breathing dust developed
when using your tool (example:- working with wood,
especially oak, beech and MDF.)
Labels on tool
The following pictograms are shown on the tool:
Warning! To reduce the risk of injury, the user must
read the instruction manual.
Wear safety glasses or goggles when operating this
tool.
Wear ear protection when operating this tool.
Electrical safety
This tool is double insulated; therefore no earth wire is
required. Always check that the power supply corresponds
to the voltage on the rating plate.
•
If the supply cord is damaged, it must be replaced by
the manufacturer or an authorised Black & Decker
Service Centre in order to avoid a hazard.
Using an extension cable
If an extension cable is requred, use an approved extension
cable suitable for the power input of this tool (see technical
data). The minimum conductor size is 1.5 mm2. When using
a cable reel, always unwind the cable completely.
Also refer to the table below.
6
All manuals and user guides at all-guides.com
Conductor size (mm
0.75
1.00
1.50
2.50
4.00
Voltage
220-240
Features
This tool includes some or all of the following features.
1. Variable speed switch
2. Lock-on button
3. Forward/reverse switch
4. Mode selector
5. Tool holder
6. Side handle
7. Depth stop
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplugged.
Fitting the side handle
•
•
•
2
)
7.5 15 25 30 45
Amperes Cable rating (Amperes)
0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
Turn the grip counterclockwise until you can slide the
side handle (6) onto the front of the tool.
Rotate the side handle into the desired position.
Tighten the side handle by turning the grip clockwise.
Cable rating (Amperes)
6
10
15
20
25
Cable length (m)
60
6 6 6 6 6 6
6 6 6 6 6 6
6 6 6 6 10 15
10 10 10 10 15 15
15 15 15 15 20 20
20 20 20 20 25 -
Publicité
