Tripp-Lite P130-000-AUDIO2 Manuel De L'utilisateur page 3

Installation
Notes:
• Make sure all devices you are connecting to are powered off prior to installation.
• 2.0 channel audio is supported regardless of the source device. The source
device must support 5.1 channel surround sound via the SPIDIF port for the
audio to work properly. The Auto setting bypasses any audio format that the
source device supports.
• If the source outputs 2.0 channel audio, the audio can output from either the
stereo or SPDIF port. If the source outputs 5.1 channel audio, the audio only
outputs from SPDIF port.
1. Optional: Mount the unit to a wall or other surface using the included
mounting hardware.
2. Using an HDMI audio/video cable, connect the HDMI source to the
HDMI input port on the unit.
3. Using a second HDMI audio/video cable, connect an HDMI monitor to
the HDMI output port on the unit.
4. Connect the unit to a set of speakers, an audio receiver or other audio
system using the 3.5 mm stereo, TOSLINK or RCA digital outputs.
5. Connect the included external power supply to the unit and plug it
into a Tripp Lite Surge Protector, Power Distribution Unit (PDU) or
Uninterruptible Power Supply (UPS). The unit's red Power LED will
illuminate to indicate it is receiving power.
6. Turn on the power to the connected devices. The red Power LED will
change to purple to indicate the unit is transmitting video and audio from
the source to the display and sound system.
7. Using the switch next to the HDMI input port, toggle between 5.1
channel surround sound, 2-channel stereo and Auto setting.
3