3
Installing the HDD Rubber Case
Pick an appropriate rubber case according to the HDD thick, and cover the rubber
case on the two sides of the HDD, as shown in the figure below.
If the HDD is 9mm thick, the TOP mark of the rubber case should be facing
upward when installing .
4
Installing the HDD
Connect the HDD cable to the HDD and place the HDD in the designated position,
as shown in the figure below.
5
Completing Installation
Replace the cover and fasten the 4 screws in the step 1 and complete the
installation.
All manuals and user guides at all-guides.com
2