NOMA 52-2533-6 Manuel D'instructions page 5

All manuals and user guides at all-guides.com
ELECTRICAL CONNECTION
WARNING:
according to the electrical safety. The wall heater must be grounded in
accordance with all national and local building codes. All electrical
connections shall be made inside the junction box at the back of the unit.
1. Connect the grounded wire to the grounding screw and connect the electrical
wires with provided wire connectors.
2. Connect all wires from the circuit breaker to the heater with wire connector.
3. Connect to supply wires according to circuit diagram in preceding section of this
user manual and circuit diagram labeled in wiring compartment of the unit.
INSTALL THE FRONT PANEL
1. Attach the Front Panel to the heater and lock in place with screws. Ensure the
grill opening matches with the fan of heater.
MOUNTING SURFACE BOX
A surface mounting box has been provided as OPTIONAL kit.
1. Ensure to keep the surface box at least 8" (20.3cm) away from any adjacent
surfaces, ceilings and floor. This minimum distance must be maintained.
2. Attach the surface box on wall with four screws provided.
3. Attach the recess box into surface box with four screws provided.
4. Attach the front panel to the heater and lock in place with screws. Ensure the grill
opening matches with the fan of heater.
OPERATION
Adjust the thermostat to increase/decrease the temperature setting.
All wiring must be installed by a certified electrician
- 5 -