Rheem RETST700SYS Guide De Démarrage Rapide page 8

1. Turn off power
WARNING: Turn off
power to HVAC system
at circuit breaker
4. Connect wires to the
thermostat terminal
Note the wire color used
for each terminal; it's good
practice to use the same wire
color on identical termination
points on the indoor and
outdoor units.
R C S1 S2 E1 E2
Tip: When installed correctly,
the release lever of the
terminal block will lower to
indicate engagement.
S1
S2
> Return to Table of Contents
All manuals and user guides at all-guides.com
2. Place ferrite toroid
(if provided) around
thermostat wires and
nest in drywall
Interior view of wall
5. Attach display to
mounted wall plate
3. Secure the wall plate
Use the dry wall anchors and
screws provided.
Tip: Ensure the back plate
is straight by centering the
bubble on the built-in level.
6. Turn power on
Power system back on
and let the EcoNet Smart
Thermostat auto configure
your equipment.
R
E1
Full Instructions
E2
RECOMMENDED: Scan the QR
C
code below using your mobile
device to view the full instructions.
OUTDOOR UNIT
EcoNet Smart Thermostat Quick Start Guide
®
R
E1
E2
C
INDOOR UNIT
8