DeLOCK 87794 Mode D'emploi page 3

English
Package content
• DisplayPort Splitter
• USB power cable, length: ca. 1 m
• User manual
Safety instructions
• Protect the product against moisture
• Protect the product against direct sunlight
Installation
1. Ensure your computer system and monitors are powered off.
2.
Connect the splitter to your video source.
3.
Connect the outputs of the splitter to the monitors with optional cables.
4. Connect the included USB cable to the splitter and a 5 V / 2 A power supply.
5. Power on your monitors followed by your computer system.
Note
• The product is a Multi-Stream Transport (MST) hub and supports the extended
desktop configuration of DisplayPort. In Windows, the connected monitors are
controlled individually, and can be combined into one large display.
• A single DisplayPort 1.4 connection has a limit amount of bandwidth. This limits
the number of displays that can be connected through an MST hub depending
on the displays resolution, timing and refresh rate. Please see below for
bandwidth usage of different resolutions:
1920 x 1080 @ 60 Hz uses 11 %, 1920 x 1200 @ 60 Hz uses 15 % bandwidth
2560 x 1440 @ 60 Hz uses 17 %, 2560 x 1600 @ 60 Hz uses 19 % bandwidth
3840 x 2160 @ 30 Hz uses 22 %, 3840 x 2160 @ 60 Hz uses 43 % bandwidth
If the graphics card supports DSC, higher resolutions and refresh rates are
possible.
• Please use short length and high-quality cables, especially for higher
resolutions.
-3-