jcm-tech MINIMAN+DCS Mode D'emploi page 17

4.3 ELIMINATE INSTALLER CODE FUNCTION
Simultaneously press the keys
screen will appear:
4.4 REPLACE LOST TRANSMITTER FUNCTION
Press the key and the following screen will appear :
Then, key the code number to be replaced.
As the corresponding keys are pressed, the numbers will be
visualised on the display. For example, if you wish to replace
the code "022457", the display will show:
Once the code has been entered, press the key
will be asked for the replacement number.
Remember that if you enter a replacement number lower than the number that
was being used in the installation, the new modified, served command will not
work. If you leave the same replacement number, the lost transmitter intended
for replacement and inutilisation will not be annulled in the receiver.
Key the corresponding replacement number (from 0 to 7) and
press the key . A short beep and the momentary appearance
of the confirmation screen will indicate that the operation has
been carried out correctly.
You will automatically return to the previous menu and be
able to repeat the function as many times as you wish.
4.5 ENTER TRANSMITTER INSTALLATION "PIN" FUNCTION
Press the key and the following screen will appear:
Then, key the four figures corresponding to the PIN of the
installation. As you press the numerical keys, the display will
visualise the numbers. For example, if the PIN is "1234", it
will show:
Once the code has been keyed, press
will tell you to insert the transmitter:
and , and the following
Then insert the transmitter in the connector and press any
channel button. A short beep and the momentary
appearance of the confirmation screen will indicate that
the operation has been
carried out correctly.
Once finished, you will return to the previous screen.
This operation may be repeated as many times as
necessary.
and another screen
15
and you