Farberware CM3004SC Mode D'emploi page 4

13. When coffee stops flowing into carafe, the brew cycle is complete. Coffeemaker beeps
when brew cycle is finished. The time since brewing will be visible at the bottom of the
digital display.
14. once coffee grounds have cooled, carefully open the cover and, using basket handle,
remove and discard used grounds. Close cover.
15. The coffeemaker will keep brewed coffee hot for 2 hours and then automatically turn off.
(See KEEPING COFFEE HOT - AUTO OFF section.)
16. To turn off the coffeemaker at any time press the I/o button. The I/o light shuts off.
BREWING 1 TO 4 CUPS
Note: This feature slows down the brewing to extract the best flavor when brewing a small
amount of coffee.
1. Add the appropriate amount of water for the number of cups to be brewed (from 1 – 4)
2. Fill the permanent filter or paper filter with desired amount of coffee grounds.
3. Press the BREW button down so that the button is in the 1 – 4
Note: When using this feature coffee will be brewed at regular strength only.
4. Press the I/o button, its light illuminates and the brewing cycle begins.
Note: Press the I/o button to cancel this function.
SNEAK-A-CUP ®
FEATURE (TO BE USED ONLY FOR COFFEE)
Remove the carafe and brewing is paused. The carafe must be placed back on the carafe plate
in 30 seconds to prevent overflow. Brewing begins again.
Important: The Sneak-A-Cup ® feature cannot be used when making tea because the filter
basket holder is removed when brewing tea. You must wait until the tea has finished
brewing.
KEEPING COFFEE AND TEA HOT - AUTO OFF FUNCTION
Once coffee has brewed, the coffeemaker will keep the "Keep Hot" carafe plate hot between
1 and 2 hours then it shuts off automatically. during that time the time since brewing is visible
at the bottom of the display.
There are 2 preset AUTo oFF times you can select:
• Press the AUTO OFF button to select 2 hours (2).
• Press the AUTO OFF button a second time to select 1 hour (1).
BREW STRONG
1. If stronger coffee is desired, press the
illuminates and function is activated.
2. If using delayed brewing, follow steps 1 through 5 under DELAYED BREWING, press the
button and then press the AUTo button. To cancel, press the
and the light turns off.
BREWING TEA
Note: It is not necessary to set the clock to brew tea unless you want to use delAYed
BREWING.
1. open cover.
2. Fill water reservoir with desired amount of cold tap water. do not exceed the 12-cup
(MAX) level on the water reservoir.
3. Remove the permanent filter and the filter basket from the coffeemaker to avoid getting
coffee flavor in the tea.
4. Close cover. Fill the removable stainless steel permanent tea filter with the desired amount
of loose tea leaves.
5. Insert the tea filter with the arc at the top of the basket placed toward the pour spout on
the carafe; press down until it is securely in place.
6. Make sure carafe lid is properly attached to the carafe. Close the lid.
6
All manuals and user guides at all-guides.com
position.
button before pressing the I/o button. Its light
button again
Note: Hot water may overflow if carafe lid is not properly placed.
7. Place carafe on the "Keep Hot" carafe plate.
8. Plug power cord into an outlet.
9. Press the TeA button. Its light illuminates.
10. Press the I/o button; its light illuminates and brewing begins.
11. When water stops flowing into carafe, the tea will be held for 5 minutes to steep.
12. When tea is ready, the coffeemaker beeps when steeping cycle is complete. The time
since brewing is illuminated at the bottom of the lCd.
Important: Sneak-A- Cup ® feature cannot be used when making tea. You must wait until
the tea has finished brewing.
13. The coffeemaker will keep brewed tea hot for 2 hours and then automatically turn off.
(See KEEPING COFFEE and TEA HOT - AUTO OFF section.)
14. To turn off the coffeemaker at any time press the I/o button. The I/o light shuts off.
15. Unplug appliance when not in use.
Note: do not leave tea in the tea pot or tea leaves in the stainless steel permanent filter
overnight.
DELAYED BREWING FOR COFFEE AND TEA
FOR COFFEE
1. Follow steps 1 through 10 under BREWING COFFEE.
2. Make sure clock has been set to correct time of day.
3. Press the program (PROG) button.
Note: If the coffeemaker has not been unplugged the last delayed brewing time will
appear on the digital display.
4. To change the time: press HR button until the desired correct time appears on the
display. Press the MIN button to select the minutes.
Note: If the hour is not changed the clock will CONTINUE TO FLASH 12:00.
5. Press the AUTo button to activate the delayed brewing. The AUTo light illuminates.
6. To check the preset auto time, press PROG button and hold it. Once button is
released, the clock time displays again.
7. If you want to change the preset auto time, press the AUTo button to cancel the
preset time. The light turns off.
8. Follow steps 3 through 6 under DELAYED BREWING.
9. To cancel delayed brewing, press the AUTo button. The AUTo light shuts off. To brew
coffee, immediately press the I/o button.
FOR TEA
1. Follow steps 1 through 10 under BREWING TEA.
2. Follow steps 2 through 10 for DELAYED BREWING for coffee.
Care and Cleaning
This product contains no user serviceable parts. Refer service to qualified service
personnel.
CLEANING
• Be sure the unit is unplugged and has cooled.
• Open the cover.
• To remove the filter basket, grip the handle and lift straight up. Discard the paper filter, if
used, and the coffee grounds.
• Wash the filter basket, permanent coffee filter, tea filter, carafe and carafe lid in
dishwasher, top rack or wash by hand in hot water and soap.
7