Lightcloud LCDAYLIGHT RCL Mode D'emploi page 10

Functionality
Overview
All manuals and user guides at all-guides.com
DEVICE
BUTTON
DEVICE STATUS
INDICATOR
USB POWER
INDICATOR
AM BIEN T
LIGHT SENSOR
:
DEVICE STATUS INDICATOR
• Unlit: When not powered by USB, indicates that the device is joined to a
Lightcloud network and is operating normally
• Solid green: When powered by USB, indicates that the device is joined to a
Lightcloud network
• Green blink: After pressing the Device Button, indicates that a light level
measurement has been transmitted
• Single red blink every 10 seconds: Not joined to a Lightcloud network
• Green/Red alternating: Resetting to factory defaults
USB POWER INDICATOR:
• White: Powered by USB
DEVICE BUTTON:
• Press: Indicate in Lightcloud application and measure light level
• Hold for 10 seconds while USB powered: Force device to leave current
Lightcloud network
• Hold for 10 seconds while connecting USB power: Reset to factory defaults
and leave current network
DAYLIGHT HARVESTING:
Daylight Harvesting is the use of daylight to offset the use of electric lighting to
light a space. If there's enough daylight in a space, the Lightcloud Daylight can
make sure the lights are turned down or off, and turn them back on when the sun
goes down.
The Lightcloud Daylight automatically takes light level measurements every 10
minutes. Pressing the Device Button will make an immediate measurement. Call
or email RC, or log in to lightcloud.ca to configure actions to take at different
ight levels, such as turning off a zone when the light level exceeds 50 foot-candles.
l