Team kalorik TKG WSP 1001 Mode D'emploi page 16

All manuals and user guides at all-guides.com
Fax +32 2 359 95 50
•
During operation, spray some detergent on the wiping cloth (or wash the wiping cloth
before use) and wipe off the dirt at high places.
•
Then take off the wiping cloth and the wiping frame and attach the telescopic tube to
the wet/dry vacuum cleaner with the squeegee by inserting it at the back side of the
appliance. Turn the telescopic tube in the right direction to tighten it and fix it at the
desired length.
•
Switch the appliance on and collect the residual liquid with the squeegee.
•
If the wiping cloth is dirty after use, it should be washed and then kept dry.
USE AS WET/DRY VACUUM CLEANER
•
Push the release button and take off the dust collector.
•
Put the filter on the appliance and insert the water nozzle or dust nozzle on the dust
collector and then connect the appliance together.
Water nozzle
Dust nozzle
•
Now you can absorb dust with water nozzle or dust nozzle, or you can absorb the residual
liquid on a table with water nozzle. When vacuuming liquids, make sure the level of the
liquid never exceeds the max level of the dust compartment.
•
Never use the appliance to vacuum hot, glowing objects such as cigarettes, matches etc.
or sharp objects that could damage the filter.
•
Your vacuum cleaner can vacuum small amounts of liquid or humid particles but never
vacuum inflammable products.
•
After having vacuumed liquids or humid particles, clean the dust collector to avoid smells.
Then dry the filter thoroughly if necessary.
•
To empty the dust or clean the inside of the dust collector, insert a small screw driver into
the rubber plug hole and pry the separate cover gently, then hold the handle and pull
out slowly (or take out by hand gently if it is too tight); after emptying and cleaning, push
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
Tightening direction
Filter
Dust collector Release button
16
Assembly page 16/72
TKG WSP 1001 - 140418