Cloer 700 Manuel D'instructions page 11

Assembly of the scraper
• The curved blade attaches to the short arm of the dri-
ver and scrapes the centre column.
• The straight blade attaches to the longer arm of the
driver and scrapes the outer wall to scrape the batter
in the direction of the wire whips.
• Each scraper blade only fits into the proper driver tab.
• Once the scrapers are correctly set, they will be ready
to be used.
Using the bowl scraper:
• To attach the bowl scraper: put the driver over the
whip driver. Make sure both clips are fully latched.
• To remove the bowl scraper, simply release the two
clips and pull it free. The scrapers may come off of the
driver. Simply assembly again. To avoid a come off,
rotate the driver shaft of the scraper lightly against
the driver of the wire whips.
• The bowl scraper is designed to be used only with the
wire whips. The use together with the dough hook is
not possible or necessary, since the dough hook al-
ready brings the batter itself to the middle.
Assembly the dough hook
• The dough hook is very effective for kneading heavy
doughs like loaf batch or for mixing ingredients like
chocolate chips or fruits chunks.
• When using the dough hook, set the maximum
speed to level 2-3.
• Put the dough hook on the drive shaft and rotate it
clock-wise until it is properly seated on the drive shaft.
• Do not use the appliance without cover. This pre-
vents splashing at the beginning of mixing and helps
prevent accidental contact with moving parts.
All manuals and user guides at all-guides.com
• Caution: Do not overload the mixer! The bowl
should not be completely full. When making heavy
or stiff dough, certain mobility is necessary.
Cleaning
• Remove the attachments from the mixer before washing.
• We recommend washing all the parts per hand to
avoid plastic softening.
• The mixing bowl, (without the drive shaft), the cover and
the wire whips (without driver) are dishwasher safe.
• The drive shaft must be removed from the bowl. In
order to do this, rotate the drive shaft counter-clock-
wise and pull firmly upwards.
• After cleaning, insert the holder back into the bowl
and lock it by turning it clockwise.
• Always remove the wire whips from the holder and
wash each part separately.
• The metal whip driver should be hand washed to
maintain it's luster. Most dishwasher detergents will
dull or oxidize the aluminium alloy of the driver.
• For easy cleaning of the lid, rotate the sliding lid
clockwise until the notch on the sliding lid lines up
with the hole in the cover. Lift the sliding lid straight
up to separate the two pieces. To re-connect align
the center notch of the sliding lid with the hole in the
cover and the sliding lid will drop easily into place.
After the cleaning:
• Before setting the bowl on the motor base again,
make sure everything is well dried.
• The motor base should be cleaned using a soft, damp cloth.
• Avoid the use of hard cleansers.
Environmentally friendly disposal
We use environmentally friendly packaging for the-
transport of our appliances. Please recycle cardbo-
ard/paper and plastic packaging appropriately.
ATTENTION!
Electrical appliances should not be
disposed of with the household trash.
Electrical appliances contain valuable raw materials.
When an appliance is worn-out, please take it to a
recognised recycling facility. Consult the local autho-
rities for information on recycling appliances.
Lock
Unlock
GB
11