Garland NIPON 620 DK Manuel D'instructions page 35

6. START UP INSTRUCTIONS
6.1.LIST OF MATERIALS
This machine includes the following elements that you
will find inside the box:
• Machine.
• Protector.
• Handlebar.
• Tools.
• Cutting accessories.
• Harness.
• Instruction manual.
Ensure that all elements listed above are included with
the machine. Thanks to the quality control checks at
the factory it is highly unlikely that any elements will
be missing. If you were to find any element missing,
do not use the machine until the defect has been
repaired or the machine is complete.
Using the machine with defective parts or without all
the elements can cause severe personal damages.
6.2. MOUNTING THE MACHINE
6.2.1.INSTALLATION OF THE HANDLEBAR
Install the handle on the transmission bar as shown in
the figure placing it at a distance from the accelerator
that is comfortable for you as end user. Tighten the
screw to avoid that the handle moves.
6.2.2 GUARD SUPPORT ASSEMBLY
The skirt of the protector must not be worn when
working with the cutting disk.
The transmission can be locked by inserting a tool or
screwdriver through the transmission hole and the
notch on the plate (3).
35/144
English
Protector
Guard support
Protector
Protector flap