PROEL WM202D Manuel De L'utilisateur page 6

INTRODUCTION
Thank you for choosing this PROEL product and for your trust in our brand, synonymous of professionalism,
accuracy, high quality and reliability. All our products are CE approved and designed for continuous use in
professional systems.
DESCRIPTION
The WM202D Wireless Microphones series is a UHF, quartz controlled, fixed frequency device, which
provides a reliable, high quality signal transmission.
WM202D Wireless Microphone system features 3 units: WM202D double receiver, WM2M handheld
transmitter and WM2H body pack transmitter. The system is available in two different configurations, each
of them including an ABS carrying case:
WM202DM : WM202D + 2x WM2M
WM202DH : WM202D + 2x WM2H + 2x lavalier + 2x headset
Four factory pre‐build frequencies are available, which have been accurately selected to allow the
simultaneous use of 4 devices without interference between them:
1. 863.100 MHz
2. 863.900 MHz
3. 864.500 MHz
4. 864.900 MHz
WM202D RECEIVER
See FIG. 1 at page 15:
1. DC IN
Socket for the AC/DC adaptor connection, use only the adaptor supplied with the system.
2. OUTPUT (UNBALANCED)
Unbalanced mixed A and B output with line level: connect it through a mono 6.3mm jack cable to a mixer
input.
3. OUTPUT (BALANCED)
Balanced mixed A and B output with mic level: connect it through a XLR cable to a mixer input.
4. POWER
On/off switch.
5. ON
Red LED: if lighted states that the power supply is present and the receiver is turned on.
6. RF (channel A or B)
Green LED: if lighted states that the transmitter is sending a radio signal to the receiver.
7. AF (channel A or B)
Red LED: illuminates when an audio signal is present.
8. VOLUME (channel A or B)
Volume potentiometer: set this control to a proper level that doesn't saturate the mixer input channel.
9. ANTENNA
These are the receiving antennas. Raise them up during the use and, to obtain a better reception, place
the receiver away from other metal objects and no more distant than 30m from the transmitter.
10. RECEIVING FREQUENCY
In this label, together with the general data of the receiver, you can find the receiving radio frequency.
In case of use of more radio apparatus it must correspond to the frequency of the wireless transmitter
6