Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
FORM FIT
Scion TC 2011 -
Hardware Kit
6 – Push Type Retainers
1 – Type A Metal Brackets
2 – Type B Metal Brackets
5 – 3M Anti-Abrasion Film Pads
5 – Large Bumpons
Installation
1.
Be sure that the hood is clean and dry inside and out.
2.
Install the five (5) bumpons as shown in Illustration. Attention: The bumpons must be installed on the hood not on the protector!!! If the bumpons
are installed on the protector, they will wear through the paint.
3.
Open the hood of the vehicle. Peel and fold anti-abrasion film pads in half over the edge of the hood, in the three (3) locations shown. Center the film
pads with holes identified in the illustration.
NOTE: Use the metal Brackets Guide to determine the type of bracket used in the following steps.
Type A
All manuals and user guides at all-guides.com
HOOD PROTECTOR
2 – #6 x 5/8" Flat Head Screws
2 – Clip Bodies
2 – Pins
2 – 'L' Brackets
55mm
105mm
Looking at underside of the hood
Anti-abrasion Pad and Metal Bracket Locations
Type B
335mm
105mm
Type A
Metal Brackets Guide
Type B
Tools Required
1 – Phillips Screwdriver #2
1 – Tape Measure
55mm
Type B
HD 30C 10
Publicité
Manuels Connexes pour FORM FIT HD 30C 10
Sommaire des Matières pour FORM FIT HD 30C 10
- Page 1 FORM FIT All manuals and user guides at all-guides.com HOOD PROTECTOR HD 30C 10 Scion TC 2011 - Hardware Kit Tools Required 6 – Push Type Retainers 2 – #6 x 5/8” Flat Head Screws 1 – Phillips Screwdriver #2 1 –...
- Page 2 Avoid using automatic car washes. Do not pull on the protector when opening or closing the hood. Thank you for purchasing a form fit hood protector. Retain this sheet for care instructions and kit information. Made in Canada...
- Page 3 FORM FIT All manuals and user guides at all-guides.com PROTECTEUR DE CAPOT HD 30C 10 Scion TC 2011 - Sachet de fixation Outils requis 6 – Push type de retenues 2 – Vis à têtes plate (n°6 x 5/8po.) 1 – Tournevis à embout étoilé n°2 1 –...
- Page 4 Éviter de laver le véhicule dans un lave-auto automatique. Ne pas tirer sur le protecteur pour ouvrir ou fermer le capot. Merci de vous êtes procuré un protecteur form fit. Conserver cette feuille pour les instructions d’entretien et les renseignements concernant le nécessaire d’installation.