Lince SUPRATRONIK 4940TK Guide D'utilisation page 7

Setting the remote controls

In the rear part of the lock there is a WHI-
TE KEY (1) hidden inside the body.
1. LINK REMOTE CONTROLS: The remo-
te controls that are delivered with the locks
come UNLINKED with the lock. The same
remote control can be linked to more than
one lock.
LINKING operation:
1.1 Press the WHITE KEY (1) until the
LED (6) lights up in orange. (Wi-
thout acoustic signal).
1.2 Press any key on the remote con-
trol (8) (9) and observe that the LED
(6) changes to green, and the re-
mote control is linked. (Repeat this
step with the different remote con-
trols to be linked).
1.3 Once the operation to LINK REMO-
TE CONTROLS has been comple-
ted, wait for the LED (6) to switch
off automatically.
1.4 Check that the remote controls
that have been linked are working
correctly from the inside.
*Each lock allows the linking of 340 re-
mote controls.
**This operation does not delete remote
controls previously recorded and allows
you to add new ones.
2. DELETE ALL THE REMOTE CON-
TROLS:
2.1 Press and hold the white button (1)
until the LED lights up in RED and you
hear an acoustic signal.
LOST REMOTE CONTROL: In the event that
a remote control is lost you must carry out
the deleting of remote controls and repeat
step 1 with the remaining remote controls.
The lost remote control will no longer work.
SUPRATRONIK LOCK: USER MANUAL
Operation of lock with remote

control
1. Press the CLOSE button (8) on the
remote control. The RED LED will light
up for the duration of the operation and
you will hear a BEEP when it has finished.
This means that the lock is CLOSED.
*The CLOSING operation should be ca-
rried out AFTER making sure, using the
main lock, that the door is properly clo-
sed.
2. Press the OPEN button (9) on the re-
mote control. The GREEN LED will light
up for the duration of the operation and
you will hear two beeps when it has finis-
hed. This means that the lock is OPEN.
*The operation of OPENING the lock
should be done BEFORE opening the
main door lock.
3. FAILED OPERATION: A CLOSING or
OPENING operation that is not carried
out correctly will lead to a FAILED ope-
ration. In this event the lock will BEEP
FOUR TIMES and the ORANGE LED
(6) will light up, indicating that it has not
been possible to complete the selected
operation. In this case the lock will be
ready for a new attempt.
**A FAILED OPERATION may be due to:
3.1 Friction between the lever and the
keep in the door frame, due to in-
correct installation or because the
door has settled, so that the lock has
gone out of alignment.
3.2 The LOCK (8) command is ac-
tivated from the remote control
before the door is completely
closed. In this case the lever will
collide with the keep without en-
tering the housing correctly.
7