MasterCraft 058-9402-4 Mode D'emploi page 4

• Test the fit of the headband by lifting up and closing down the
helmet a few times while wearing it. If the headband moves while
tilting, re-adjust it until it is stable.
• HEADGEAR ADJUSTMENT
Head Size Adjustment: Headband tightness is adjusted by
pushing in the ratchet knob and turning to adjust to desired
comfort level. This knob is located at the back of the helmet
(see "Y" in Fig. 1). Head Gear Crown Adjustment is made by
adjusting crown strap for vertical placement on the head and
snapping the pin into the hole to lock securely in place (see "W" in
Fig. 1).
Tilt: Tilt is adjusted on the left side of the helmet. Tilt is adjusted
by loosening outside tension knob and releasing the adjustment
lever from its current location and moving it to another location (see
Fig. 2). Retighten the outside tension knob when finished (see "T"
in Fig. 1)
• REPLACING FRONT COVER LENS PLATE. (See Fig. 4)
Replace the front cover lens plate if it is damaged (cracked, scratched, soiled or pitted).
• REPLACING THE AUTO-DARKENING FILTER. (See Fig. 4)
Replace the auto-darkening filter if it is damaged (cracked, scratched, soiled or broken),
and fit a new lens.
• CHANGING THE SHADE CARTRIDGE. (See Fig. 3)
• CLEANING
Clean helmet by wiping with a soft cloth. Clean lens surfaces regularly. Do not use strong
cleaning solutions.
Fig. 3
All manuals and user guides at all-guides.com
MAINTENANCE
3
TOP
T
Fig. 1
Y
Fig. 2
Fig. 4