Publicité
Les langues disponibles
Les langues disponibles
COMMON PROBLEMS AND REMEDIES
• Irregular darkening or dimming
Headband has been set unevenly and there is an uneven distance from the eyes to the
filter lens. (Reset the headband to even out the distance to the filter.)
• Auto-darkening filter does not darken or flickers
① Front cover lens is soiled or damaged. (Change the cover lens.)
② Sensors are soiled. (Clean the sensors' surface.)
• Slow response
Operating temperature is too low. (Do not use at temperatures below -5 ºC or 23 ºF.)
• Poor vision
① Front/inside cover lens and/or filter are soiled. (Change lens.)
② There is insufficient ambient light.
③ Shade number is incorrectly set. (Reset the shade number.)
• Welding helmet slips
Headband is not properly adjusted. (Readjust the headband.)
The user must stop using the auto-darkening welding helmet immediately if the
WARNING! Before using the helmet for welding, ensure that you have read and
BEFORE FIRST USE
1) The auto-darkening welding helmet needs to be charged prior to use and after extended
storage. Leave the solar panel on the helmet facing the sun or bulb light for at least one
hour before first use.
2) Remove the protective shipping film from both sides of the front lens (if not already done).
3) The helmet comes assembled, but before it can be used, the headgear must be adjusted
for proper fit.
• ADJUSTING THE FIT OF THE HELMET
The overall circumference of the headband can be made larger or smaller by rotating the
knob on the back of the headband. (See adjustment "Y" in Fig. 1). This can be done while
wearing the helmet and allows just the right tension to be set to keep the helmet firmly on
the head without it being too tight.
• If the headband is riding too high or too low on your head, adjust the strap which passes
over the top of your head. To do this, release the end of the band by pushing the locking
pin out of the hole in the band. Slide the two portions of the band to a greater or lesser
width as required and push the locking pin through the nearest hole. (See adjustment "W"
in Fig. 1.)
All manuals and user guides at all-guides.com
WARNING
Severe personal injury could occur if the user fails to heed the above
mentioned warnings or fails to follow the operating instructions.
WARNING
above-mentioned problems cannot be corrected. Contact the dealer.
INSTRUCTIONS FOR USE
understood the safety instructions.
2
Publicité
