Publicité
Les langues disponibles
Les langues disponibles
RX510
Troubleshooting
Symptom
No detergent
suction
Unit begins to
smoke
Pressure washer
does not start up
Pump does not
reach necessary
pressure
Fluctuating
pressure
Motor stops
suddenly
Technical Data
Item
Working pressure
Allowable pressure
Working flow rate
Maximum flow rate
Maximum water input pressure
Motor capacity
Power supply voltage
Maximum water temperature
All manuals and user guides at all-guides.com
Possible Cause(s)
• Detergent applicator is clogged
• Overheated, overloaded or
damaged motor
• Unit is pressurised
• Plug is not connected correctly
or electrical supply is damaged
/ faulty
• Thermal safety switch has
tripped
• Water inlet is clogged
• Pump sucking air from hose
connections
• Nozzle is worn or not correct
size
• Unloader / valves are clogged/
worn
• Pump is sucking air
• Clogged nozzle
• Valves dirty, worn or clogged
• Water seals worn
• Thermal safety switch has
tripped due to overheating
English
• Clean applicator with warm water
• Replace applicator
• Turn off unit and call the dealer
• Clean water inlet
• Check that connections and locking
ring are properly tightened
• Switch off unit and allow to cool
down
• Clean water inlet filter
• Check that connections and locking
ring are properly tightened
• Call the dealer
• Call the dealer
• Check that hoses and connections
are tight
• Clean with tip cleaner
• Call the dealer
• Call the dealer
• Check mains supply voltage
corresponds to specifications
RX510
9 MPa (90 BAR)
13.5 MPa (135 BAR)
6.0 Litres / min
7.5 Litres / min
0.4 MPa (4 BAR)
1800 Watt
240V ~ 50HZ
50°C
© Wilks-USA
Corrective Actions
9
Publicité
