Publicité
Les langues disponibles
Les langues disponibles
1. Brand plate
2. Front grill
3. Grills clips
4. Small blade
5. Large blade
6. Lock ring of rear grill
7. Rear grill
8. Motor shaft
9. Handle
10. Oscillation knob
4. ASSEMBLY
WARNING : Before assembling your appliance, carefully read the
safety instructions in this manual.
1. Remove the locking mechanism (18) at the bottom of the tube ; turn
counterclockwise. Insert the tube in the center of the base (17) and
replace the mechanism in order to secure the assembly of the tube and
the base ; turn clockwise.
2. Position the fan body correctly on the extensible tube (15) and
tighten the locking knob to secure the assembly ; turn clockwise. If
necessary, first loosen the ring (16) by turning anti-clockwise in order to
be able to adjust the height of the extensible tube, then tighten the ring
by turning clockwise.
3. Remove the rear grill locking ring (6) from the motor housing ; turn
counterclockwise. Position the rear grill (7) correctly on the motor
housing, by aligning the 3 raised knobs on the top of the motor housing
with the 3 holes on the rear grill and make sure the indents of the rear
grill is on the bottom.
4. Replace and screw the rear grill locking ring (6) onto the motor
housing to secure the rear grill assembly ; turn clockwise. Be sure to
tighten the ring properly.
5. Insert the large blade (5) onto the shaft of the motor until it stops.
Then insert the small blade (4) on the shaft and tighten it against the
large blade ; turn counterclockwise. Take care to tighten the small
blade correctly. Check that the blades turn well by turning them
manually.
11. Motor housing
12. Angle ajustable
13. Remote control storage
14. Fan body
15. Extensible tube
16. Height adjuster
17. Fan base
18. Base locking mechanism
19. Control panel
20. Remote control
20
Publicité
