MS-7760 Manboard
▶
tWRDRDD
Wrte-Read Dfferent Ranks same or Dfferent DIMM.
▶
tRWSR
Read-Wrte Same Rank.
▶
Spread Spectrum
Ths functon reduces the EMI (Electromagnetc Interference) generated by modulatng
clock generator pulses.
Important
•
If you do not have any EMI problem, leave the settng at [Dsabled] for optmal system
stablty and performance. But f you are plagued by EMI, select the value of Spread
Spectrum for EMI reducton.
•
The greater the Spread Spectrum value s, the greater the EMI s reduced, and the
system wll become less stable. For the most sutable Spread Spectrum value, please
consult your local EMI regulaton.
Remember to dsable Spread Spectrum f you are overclockng because even a slght
•
jtter can ntroduce a temporary boost n clock speed whch may just cause your
overclocked processor to lock up.
▶
Vdroop Control
Load lne droop controls the stream of current to the CPU.
[Auto]
[Low VDroop]
▶
CPU Core Voltage/ System Agent Voltage (SA)/ CPU I/O Voltage/ CPU PLL Voltage/
DDR CH_A/B Voltage/ DDR CH_C/D Voltage/ DDR CH_A CA Vref Voltage/ DDR CH_B
CA Vref Voltage/ DDR CH_C CA Vref Voltage/ DDR CH_D CA Vref Voltage/ DDR
CH_A DQ Vref Voltage/ DDR CH_B DQ Vref Voltage/ DDR CH_C DQ Vref Voltage/
DDR CH_D DQ Vref Voltage/ PCH 1.1 Voltage/ PCH 1.5 Voltage.
These tems are used to adjust the voltage of CPU, Memory and chpset.
▶
Current CPU Core Voltage/ Current SA Voltage/ Current DDR CH_A/B Voltage/
Current DDR CH_C/D Voltage
These tems show current CPU/ DRAM voltage. Read-only.
▶
Overclockng Profiles
Press <Enter> to enter the sub-menu.
▶
Overclockng Profile 1/ 2/ 3/ 4/ 5/ 6
Press <Enter> to enter the sub-menu.
▶
Set Name for Overclockng Profile 1/ 2/ 3/ 4/ 5/ 6
Gve a name by typng n ths tem.
▶
Save Overclockng Profile 1/ 2/ 3/ 4/ 5/ 6
Save the current overclockng settngs to ROM for selected profile.
▶
Load/ Clear Overclockng Profile 1/ 2/ 3/ 4/ 5/ 6
Load/ Clear the stored profile settngs from ROM.
En-40
Automatcally sets values for maxmum stablty.
Provdes less fluctuaton (better for overclockng).