Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUCTIONS
CONTROL PANEL
1. Auto defrost light: The light will illuminate when frost builds up on the evaporator coils. The compressor
will cycle off and the fan will continue to run until the frost melts.
2. Bucket full light: The light will illuminate when the bucket is full or incorrectly positioned inside the
cabinet. The compressor and fan operation will stop as a safety feature. When the bucket is emptied or
correctly re-positioned the dehumidifier will resume operation automatically.
3. Display: Shows the actual (± 5% accuracy) room humidity level in a range of 30% to 90%. Otherwise,
displays selection when programming humidity or timer.
4. Pump button: Press to activate the drain pump. Ensure that a drain hose is connected before starting
the pump.
5. Smart dehumidify: This function will automatically adjust the humidity level with the fluctuating room
temperatures. The humidity level cannot be adjusted in this setting, it will stabilize between 45% - 55%.
Press the humidity adjust buttons to cancel this feature.
6. Filter button: The check filter light will flash after 250 hours of operation. After cleaning the filter, press
the filter button to turn off the light. Press and hold the filter button for 3 seconds to activate the wireless
feature.
7. Continuous button: Press to activate the continuous dehumidifying operation.
8. Fan button: Press to select normal or high fan speed. The light will illuminate when set to high fan
speed.
9. Timer button: Press to set the timer.
10. Humidity adjust buttons: The humidity level can be set within a range of 35% to 85% relative humidity
in 5% increments. For drier air, set to a lower percentage value. For more damp air, set a higher
percentage value.
11. Power button: Press to turn the dehumidifier on or off.
4
5
1
7
6
2
8
9
4
3
10
11
Publicité
