Cleanfix DS 5 VDE Mode D'emploi page 13

Operating Procedures
Fill the cold water tank (3) with clean cold water
only.
Connect the Vacuum Hose to the front of the
machine (7) ensuring it locks into position. To
release the vacuum hose from the socket slide
the red button upwards at the same time as
pulling the hose out.
If the Hose becomes damaged the complete hose
must be replaced. Do not attempt this task
yourself, contact a Cleanfix approved supplier for
replacement.
Connect the Steam Hose to the front of the
machine (8)
Ensuring it is pushed in all the way and the pin on
the flap locks into the hole on the hose.
DS 5 - Englisch
Anything other than
clean cold water used
in the water tank will
void the manufacturer's
warranty.
Ensure the steam hose
cannot be pulled out.
IMPORTANT
-
Grease "O" rings on steam pin before
connecting.
-
To release the steam hose, lift the flap
and pull.
- Plug the power cable into a 240 Volt
supply.
IMPORTANT
-
Inspect the electric cable before every
use. If the cable becomes damaged at
any time the complete cable must be
replaced by a Cleanfix approved
distributor.
-
Never touch the power cable or plug with
wet hands
- Always unplug the machine when the
machine is not in use when:
o Cleaning the machine
o Any maintenance work is being
carried out
Switch the On/Off switch (10) to the ON position.
The Heater On light LED (12) will illuminate.
Allow approximately 5 minutes for
the boiler to heat the water
When the Steam Ready LED (13) illuminates the
machine is ready to be used.
The handle controls are now active.
13