Publicité
F R E Q U E N T LY A S K E D Q U E S T I O N S
TROUBLE
• Unit does not turn on.
• Mist output minimal to none.
• Filter Check does not work.
• Filter turns brown.
QUESTIONS
• What are the variables that affect
run time?
• How do I remove film on water tank?
• How can I extend the run time?
T R O U B L E S H O O T I N G
All manuals and user guides at all-guides.com
TROUBLESHOOTING
PROBABLE CAUSE
Not plugged in.
Outlet not functioning.
Filter has not absorbed water.
Cool mist is invisible.
Not plugged in.
Outlet not functioning.
The filter has absorbed minerals.
FREQUENTLY ASKED QUESTIONS
ANSWER
The estimated run time for this humidifier is based on average
room conditions. The actual run time of your humidifier is
dependent on numerous variables such as:
Air exchange in the room where the humidifier is placed.
✔
Room construction where the humidifier is placed.
✔
Temperature of the room where the humidifier is placed.
✔
Humidity levels in the room where the humidifier is placed.
✔
Movement of occupants and the opening and closing of doors in
✔
the room where the humidifier is placed.
Home furnishings in the room where the humidifier is placed.
✔
See Daily Maintenance instructions. Regular cleaning is
✔
recommended.
Run your unit on the lowest setting.
✔
If your unit has electronics, set it to your desired humidity
✔
level. The unit will turn on and off, which will extend the
run time.
Fill the tank all the way full, place it on the base,
✔
let the water empty into the base until it stops bubbling,
then refill the tank full again. This ensures maximum
water capacity and will extend run time.
SOLUTION
Plug in unit.
✔
Wait 15 minutes for filter to absorb water.
✔
Operate on High (3).
✔
Wait 60 minutes to activate
✔
(continuous use).
Replace your filter (SWF64)
✔
by calling 1-888-264-9669,
or visit www.sunbeam.ca.
Publicité
